Beurer GL Betriebsanleitung PDF herunterladen (Seite 20)

Beurer GL32 mg/dL

Carefully remove the needle lancet from the lancing

device and discard the lancet in a suitable sharp-proof

container.

Carefully dispose of all blood samples and materials

with which you have come into contact. This prevents

injury and prevents infection spreading to other people.

Twist the (grey) cap back in place.

5.2 Measuring the blood sugar value

Hold the measuring device so that the display is facing you.

Insert a test strip, contacts first, into the device. Ensure that the front side is

facing you. You can handle any part of the test strip with clean, dry hands.

The device switches on automatically and shows the start display, shortly

followed by the checking symbol “

“ . As soon as the flashing blood droplet

symbol 6 is displayed, the device is ready to perform measurements.

Hold the blood collection slit (at the point of the test

strip) against the blood droplet. Do not press the

puncture site (fingertip or other body part) against the

test strip. The blood must not be smeared. The blood

is sucked into the slit.

WARNING

Hold the blood collection slit of the test strip against the blood

droplet until the slit is completely filled and you hear a beep.

Withdrawing the test strip from the blood droplet before the beep

may lead to incorrect measurements.

Once the slit is filled with blood, the device performs the blood sugar meas-

urement. The measuring device counts down for 6 seconds, and the result of

the measurement is then shown in the display. Read the measured value. For

an explanation of the measured value and possible actions, see the next

chapter "5.3 Evaluating the measured value", page 19.

If an error message is displayed, refer to chapter “8 Troubleshooting" on page 29.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 35 36

Keine Kommentare

Beurer GL Betriebsanleitung Seite 20